Repairing, grinding and polishing Bottle King, East Windsor, NJ
This floor was in extremely bad shape, with 5 different slabs many concrete patches and divots etc. Shot Blast Inc. completely repaired the concrete floor and left a polished concrete finish that will last for years. Expansion Joints were cut out and filled with a special PolyUrea joint material. The surface was ground from 20 grit Metal bond diamonds up through 800 grit resin bond diamonds, the surface was chemically densified to harden the surface and two coats of a penetrating guard product to seal off the polished surface, then burnished.
-
- 12,000 square feet of concrete surfaces before polishing starts
-
- Floor surface has old tile mastic, paint and dirt.
-
- This is an area that was the mock up to show what the floor would be like after grinding, polishing, staining, etc.
-
- Grinding with 20 grit metal bond diamonds using a Huska Varna planatary grinder running off 480 volts 3/phase electricity
-
- Concrete Joint being cut open for filling with a polyurea joint material
-
- Control joint cut down 2″ and ready for filling with polyurea
-
- Slab dropped in one area and the higher edge had to be ground down to meet the lower slab.
-
- Before
-
- Applying stain after 400 resin grit grind, notice the squares in the floor left over from tile previously installed on floor, these shadows are permanately visible in the floor they cannot be removed.
-
- Final finish after 800 resin bond grind and guard application then burnished
-
- After
-
- finished polish floor
-
- finished polish floor
